MRC Forum- brought to you by www.morini-riders-club.com

It all makes sense now- I have the Tarozzi rear sets so hence no grease nipples. Once I get some rotation I will simply grease the shaft as it is supposed to be and put the rear sets back. Thanks for all the help- I will let you know hoe I get on when I have made the tool. By way of another topic, I...

Thanks for the help on this. I think I will have to make a tool that fits snugly on the end of the pivot in order not to damage it. Has anyone fitted grease nipples to the swinging arm?

Is there a special too available to undo the swinging arm- I have a bit of lateral play but cannot move it with a 15mm open end spanner. NLM assure me if I move the pivot round a bit , regrease and re tighten it should be OK. Sam assuming that when looking at the swinging arm from the right hand sid...

Think I have found the answer! On stripping the bike down to clean it after this ride, I found the large breather tube had been completely pinched under the seat. I have now redirected it but have not tested yet

After a 160 mile thrash up to Exmoor and back, I noticed evidence of oil expulsion from both breathers- I checked oil level and it was down the stick . Anyone got any suggestions ? Is this likely to be rings or valve guide seals?