MRC Forum- brought to you by www.morini-riders-club.com

Awesome thanks Mike - I'll drop Franco an email. Sounds like he might be a good contact for other Morini parts in the future!

Cheers!

Greg

Ahahaha... 'THe penal institution next to your islands' ...yeah, it's a pretty big penal institution ...lots of 'convicts'...!! I assume 'the Italian Meeting' you both mention was in Europe? Unfortunately it's along way from here and I don't get over there very often. Always wanted to do the Imola S...

Hello, Does anyone out there have the following for an '82 Kanguro 350: 1. Tacho - mine's just failed. Consider anything in reasonable condition (cable-driven, 80mm OD) 2. Chain guard (they eventually fall to pieces) 3. Centre Stand. Only have the side stand fitted but a centre stand would be super ...

Hello from NZ! I’ve recently rebuilt an '81 350 Kanguro engine and just fitted into the bike. Everything seems to work beautifully as it should EXCEPT for the gearbox. Whilst it shifts up through the gears nicely, when chopping down, it becomes incredibly vague and often requires several prods to ge...

Further to previous post I found these photographs this shows the press in circular central plug on the outside of tacho drive (silver grey) IMG_20190928_142405.jpg This is the broken shaft lying on the helical drive .Drifting it pushed out grey disc releasing helical drive shaft. IMG_20190928_1423...

Brilliant, thanks Tom! … I'll put an order through to Mdina (although last time I tried ordering a whole lot of Morini parts from them, they were a lot less enthusiastic than NLM used to be - I think they're primarily Ducati people!). Give Mdina another try. Doug who is the new owner of Mdina (sinc...

They are not easy to find :roll: How it should be, how problems begin and how it ends: k-DSCI0261.JPG It´s very important to distance the drive properly with the distance washers. As far as posible into the nut with the sqare hole, but with a little clearence left. The nuts can end like this: k-DSC...

Part number 46.03.29 Hard to get. Mdina have used ones in stock: https://www.mdinaitalia.co.uk/tacho-elbow-drive-350-kanguro-used.html Don’t forget club members get a 10% discount While you’re at it check that the nut on the end of the camshaft into which the tacho drive locates is in good conditio...

So to confirm you are after the one for the engine casing, not the instruments. The instrument end is back to front compared to the engine end. I had one from NLM in 2018, I'll see if the invoice is in my records for the part number. Yes - the ENGINE end. You don't need a 90º fitting for the tacho ...

I've just drawn it up for a bit of clarity on the subject....

I bought one from gutsibits in UK for my 500 SEI-V, part number HAG17361 Hopefully you have a more local source of Guzzi spares? Hello and thanks for the tip! I buy quite a bit from Gutsibits (I also have Guzzi's) and even already have one of these to compare. The output end fits perfectly with the...

Hello from New Zealand! Could anyone out there help with with a 90º tacho drive for my '81 Kangaroo 350? (that runs off the ignition timing shaft). The little square input shaft has sheared off and it looks impossible to pull apart for a repair. Interested in new, or second hand replacement ...or ev...