MRC Forum- brought to you by www.morini-riders-club.com

Hi does anyone have a good 500 flywheel for sale suitable for a late 6 speed?

Hi

Sadly i have lost the little plastic bit that the dual cables pass through as they enter the twistgrip on a Verlicchi twistgrip on my 500, does anyone have one sitting aound? ndoes not need to be the push button type as the missing bit is identical to the normal one

Regards

Kevin

Hi Tom, I think I have one on its way, if not I will let you know, Regards kevin

Hi I have lost my seat for the pressure relief valve ball on my 500, anyone have a spare or know where to gewt them? Mdina say out of stock

Regards

Kevin

Excellent thanks for the help

So both like this, they are Ariete seals so in that case springs would be exposed viewed from above?

Hi I have some nice new seals to fit to my forks but can't figure out which way up... Two seals per leg from MDina but all seals have a lip, so is it bottom one lip down top one lip up? Or both the same way? Thanks for any pointers or even Bad Manners jokes..

Kevin

Hi I have some nice new seals to fit to my forks but can't figure out which way up... Two seals per leg from MDina but all seals have a lip, so is it bottom one lip down top one lip up? Or both the same way? Thanks for any pointers or even Bad Manners jokes..

Kevin

Hi I have a set of 350 headers and balance pipe off my 350 Sport, they are fine although the balance pipe looks rough, only taken off as I purchased a bright shiny new set, would like £30 plus postage or can hand over somewhere Also a set of Marzocchi rears for a 500 with red springs, in need to a c...

Hi on the cover is a very nice yellow 350, exactly the same as mine, so how did they end up yellow and not red? Genuine question, not seen another one.

Regards

Kevin

Hi

Can we still buy chrome downpipes, I can only find stainless ones?

Regards

Kevin

Hi Anyone out there own B896 JPH red (obviously) 500 / Sei V early type, I bought it new in 1984 and would love to know if its still alvive or where it ended up

Regards

Kevin

Thanks everyone

I am now convinced it is on standard bore and have ordered the parts, now where is that postman.......

Regards

Kevin

Hi yes I am an idiot the headgasket was stck to the barrels.........

Hi, I have pulled the rear cylinder apart and the top ring had broken in two, no scores, no missing bits so will replace. The liners seem to have very little wear so pretty lucky really. The one bit I am not sure about is do piston rings come in plus sizes? Its a 62mm piston but not accurate enough ...