MRC Forum- brought to you by www.morini-riders-club.com

Hallo! I have found an almost new Morini dart 350 It has only 3.000 km on It and engine looks and sounds new Replaced the belt, repaired the brakes and some earths the bike Is ok and ready to go But i found a leaking fuel tank probably from the fuel sender and also from the welding on the lower part...

Here in UK it would most likely be Mdina Italia for the gear and brushes. They took over from NLM for the spares supply. The bearings and seals from a bearing supplier is usually best. As you are in the bikes home country though I guess there will be suppliers more local to you? Here in Italy I can...

Hi all! During the coronavirus lockdown I have a lot of free time so now it's time to rebuild the starter motor As usual sourcing parts is the hardest parts I will need the bronze gear, the seals and some cushions, I found an universal chain 3/8 on ebay will cut as needed Were do you all usually buy...

Hi Gianluca, which 501 Camel do you have? Early small tank with 6V/12V electrics or the later model which has a large tank with 12V electrics/electric start; as their forks are different. The early small tank 501's pre-load sleeve is 70mm long with an outer diameter of 32mm and it is 1.25mm thick. ...

Hi All!
My 501 camel front fork has missed the spring preload sleeve/spacer inside the fork, just under the plug on the top, no the bike is lower on the front a little bit, please someone know how long these pieces are?
Thanks in advance
Gianluca

Hi! I'm looking for the chain located inside the starter motor for my 350 k2
Please let me know via pm
Or WhatsApp me at 0039 392 828 2934
Thank you
Gianluca

Hi all!
I'm looking for a 350 k2 starter lever
Please let me know via pm
Or WhatsApp me at 0039 392 828 2934
Thank you
Gianluca

Hi! Do you still have the rear side panels? How much for them?
Thanks in advance.

looking for a 501 camel piston and gilardoni barrel

also a complete and good engine is welcomed

please let me know

thanks in advance

Gianluca

Hallo everyone!

i'm looking for a front brake pump for my morini 350 K2

the bike has twin disks on the front, so the pump is the same as the 500, it is a grimeca item and it has a 18-19mm piston

anyne can help?

a good rebuildable unit il also welcomed

thanks in advance

Gianluca

hi all!

i'm painting my 350 K2 and i'm looking for the stickers on the tank, side panels and under the seat....

where i can find them??

thanks in advance
Gianluca

I looked in the shed yesterday. No heads! sorry. There are the barrels, rocker covers, and some other stuff,but no heads. I thought I might have had them because i have a fair bit of that bike. The frame hangs in the garage. The tank is on top of a cupboard. Sorry Griffo hi! do you have a piston an...

hi all! i'm looking for some 350 k2 parts: front mask complete with headligt and the frame to the front fork good seat, mine is broke at the fixing points on the chassis left and right handlebars complete with the verlicchi supports (on the front fork) pictures of the bike are also really welcome be...

looking for

piston
piston pin
rod in good condition
barrel

all parts are for 501 camel

rod stud faild at high rpm...

hi all!

my 501 camel is leaking oil from rear shock....
where to look for spares?

thanks
Gianluca