MRC Forum- brought to you by www.morini-riders-club.com

I have a 78. Sport with 2 yellow, 1 green and 1white. Alternator. I’m trying to work out wich regulator is correct for this alternator. I have a red one and a black one.
I’m not getting any power to the battery. What regulators fit what bikes?

Silly question maybe but what’s the correct orientation for the square carburettor slides. Low side to filter or long side?
VHBZ 25

Thanks for all the input. I’m thinking I’ve made a mistake with the placement of the spacer. But I’ll be having it apart soon. I’ll follow up on the result.

I don’t have the dished plate in my clutch. Does anyone also run without one? What could be the possible faults resulting? I’m suffering heavy gear change problems. Almost have to use force sometimes to get a gear and impossible neutral selection. It’s a ‘78 3 1/2 with a nylon clutch inner ring and ...

Dear Oracle. I have recently acquired a new black mark 3 pick up and magnet from Italy. I have also a new NLM cdi. I have learnt I must introduce a diode in the red wire if it had original transducers but is this true also with the NLM unit.
Any other tips welcome.

What iridium plugs actually? Is that a resistor plug and resistor cap together?

After a long time I’m now looking at my 350 sport with NLM cdi and coils. What resistor caps and plugs are recommended on a standard engine. All input gladly appreciated.

They Allen Key Jiggle did the job. Nice one

Hi guys. My rotor is pick up rotor is stuck. Any tips or tricks to free it?

Hi Guys. Having successfully solved my previous problem I notice I have a groove just below the head of the clutch pushrod at the basket end. Just where it goes through the seal. The bike has stood still sometime and I’m wondering if this is wear or as intended.
Thanks Mike

After stripping the clutch and watching several Paul Compton you tube videos i found the problem to be quite a simple one of course. As i said the clutch actuating arm was making contact with the chain when pulled in so i assumed a clutch problem but found that i had assembled the drive sprocket aro...

After a total engine Rebuild on my 78 sport I have a problem with my clutch. My pushrods don’t seem to be long enough! I have the four rods and the last small rod only sticks out 6 mm so when I pull the lever the arm makes contact with the chain. All parts are new from NLM. I’ve heard some engines h...

I recently posted a similar question on the kickstart / break pedal issue. dont be tempted to kick it over to see how it works. i broke the Tarozzi brake arm 1st kick! as said cut a stump off the end of the brake pedal or buy a small folding rear footrest and make that work. The arm on its own cost ...

So i have tha same problem most others have. When kicking over the starter the pedal makes contact with the gearshift pedal. I have the full tarozzi set with the extended kick start pawl. what is possible to make the kickstart not hit the rear brake pedal. pictures off other bike preferred . thanks ...

Hi guys, I've spent 3 days trying to get the headlight to work. Wired up as blue book for 6 pole switch but can only get a side light. That goes out when switched to main beam. Is the handlebar switch connected to earth?
Anyone got a diagram of switchgear to headlight?
Cheers
Mike