Page 1 of 1

A Small Problem with Club supplied Tank Badges.

Posted: 30 Apr 2007 20:26
by Ballacraine
I can't sem to get the 'M' end of the badges to stay stuck down to the tank. :oops: Rest of them stick down fine.

Does anyone reckon a bit of heat to form them some, may be the answer? :?

Nige.

Posted: 02 May 2007 15:12
by robinh44
Hi,

I recented stuck my tank badges on but purposely stuck them onto bare metal for better adhesion, did not get a problem. Rather than heat can you apply additional glue and then strap the badges in place with bungees while it dries?

Regards

Robin

Posted: 04 May 2007 19:21
by Jem
Nige,

sorry to hear you're having problems. I attached mine by using silicon sealant instead of the sticky strip and held them in place while the goo set using tape (gaffer/masking - not sure, 'twas 7 years ago).
A heat gun might help but I'm not offering guarantees! (A heat gun is one of my secret workshop magic tools. Much better than an oven or blow torch for heating cases when replacing bearings: heat at the flick of a switch.)

Out of interest, the transfer people who do the shows & advertise in the classic mags have stickers for Sport/Strada tank badges and I'm considering that option when I have my tank resprayed. I would like to get them offered as an alternative product offered by the club.

Posted: 04 May 2007 21:35
by Ballacraine
Thanks for the suggestions, folks.

I may even try leaving them in boiling water and forming them against the tank whilst they are still hot....

I'll report back! :wink:

Thanks again...

TTFN

Nige.