Sprockets wanted

250 2c- the Wee-WeeVees
simonnorthroad
Posts: 388
Joined: 16 May 2017 10:57
Location: Bath, UK

Re: Sprockets wanted

Post by simonnorthroad »

B&C arent cheap, but they are very good
mbmm350s
Posts: 666
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: Sprockets wanted

Post by mbmm350s »

buzby wrote: 13 Dec 2020 11:18 This is the description on my invoice "Renthal Rear Sprocket Blank 38mm Tooling Hole (100--520-40FS)" and the cost was £51.16 including P& P, so not cheap but it fits perfectly and looks good quality.
I phoned B & C and they were very helpful and they said they had the pattern for this Morini hub so no problem and I can recommend them.
I had a new DID chain on the shelf already, left over from some other project, so I can't say how much that would cost.
Dave.
Hi Dave,

Did it work out Ok? Will be going down the same route on another 2C

Cheers
Mark
User avatar
buzby
Posts: 190
Joined: 14 Apr 2006 18:31
Location: southampton

Re: Sprockets wanted

Post by buzby »

Hi Mark
.
yes happy with this , no problems at all so far,

cheers,

Dave.
David
75 350 Strada, 76 350 Strada, 76 350 Sport. 80 250 vee, 72 Triumph TR5T and 81 Honda CB250RS
mbmm350s
Posts: 666
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: Sprockets wanted

Post by mbmm350s »

Thanks Dave
Post Reply