Page 1 of 1
Flywheel Holder
Posted: 03 Jul 2020 16:29
by Vitesse
I don't suppose anyone in the Midlands has one I could borrow for about 10 minutes! 1977 350 Sport - no electric start.
I've tried locking the bike in gear (clutch not holding enough) and a strap wrench on the flywheel but to no joy. Need to do a cambelt change so I can send my friend his puller back!
Re: Flywheel Holder
Posted: 03 Jul 2020 16:45
by George 350
Whereabouts in the midlands?
Re: Flywheel Holder
Posted: 03 Jul 2020 16:54
by Vitesse
I'm just N of Coventry - near jn2 on M6.
Re: Flywheel Holder
Posted: 03 Jul 2020 17:41
by norbert
6. gear and rear brake will do
Re: Flywheel Holder
Posted: 03 Jul 2020 17:52
by Vitesse
norbert wrote:6. gear and rear brake will do
no. It didn't.
Re: Flywheel Holder
Posted: 03 Jul 2020 20:29
by mbmm350s
At Morano-sul-po rally in Italy two men a wheel brace and a mallet undid the nut on my wifes 250 2C after the belt snapped
Shock treatment
Or a rattle gun.
Mark
Re: Flywheel Holder
Posted: 04 Jul 2020 06:26
by MickeyMoto
If your clutch slips trying to undo the flywheel nut you have another problem to resolve!
I use a 700mm breaker bar on the nut using Norbert's method.
Re: Flywheel Holder
Posted: 04 Jul 2020 10:29
by Vitesse
MickeyMoto wrote:If your clutch slips trying to undo the flywheel nut you have another problem to resolve!
It hasn't been on the road since an NLM rebuild in 2010 (hence the need for a new belt despite no miles on this one) so I'm sure I will have several problems thank you.
Re: Flywheel Holder
Posted: 04 Jul 2020 15:47
by MickeyMoto
You're welcome!