Imperial Milano

Anything to do with the 1200 Milano
Post Reply
MickeyMoto
Posts: 2113
Joined: 22 Nov 2008 17:41
Location: Even further oop North

Imperial Milano

Post by MickeyMoto »

On my trip to the SRS the plug on the front down pipe parted company on the M90. A trip to Halfrauds and a piece of aluminium and a jubilee clip fixed the blowing. I have been trying to figure out the thread and took out the rear one. After a bit of measuring and a trawl through t'interweb I bought a brass replacement.

Thread is, wait for it, 1/8" BSP... :) Easily obtained as used on lots of things...

I'll buy a few as spares!
mbmm350s
Posts: 492
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: Imperial Milano

Post by mbmm350s »

Bet you never expected to be nipping out to the "Plumb Centre" for Morini spares. :lol:
MickeyMoto
Posts: 2113
Joined: 22 Nov 2008 17:41
Location: Even further oop North

Re: Imperial Milano

Post by MickeyMoto »

No! Apparently the Italians use the 1/8" bsp in toilet cisterns!

No more comments, please!
mbmm350s
Posts: 492
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: Imperial Milano

Post by mbmm350s »

Serious comment Mike, if its the same as mine, if you mean the one in the front pipe right at the bottom, has drillings for lockwire, not sure what one could wire it too though.
Cheers Mark
MickeyMoto
Posts: 2113
Joined: 22 Nov 2008 17:41
Location: Even further oop North

Re: Imperial Milano

Post by MickeyMoto »

Mine didn't! :) you could tie it to the lambda sensor.
Post Reply