Taken from the PHBH 28s on my 501 motor, but the dimensions appear identical to the 350 chokes. Handlebar lever and back-plate included; you'll just need a bracket. This pivoted on the clutch lever pivot bolt. £20 including p&p in the UK. PM me with any questions. Thanks, Mark.
Chokes with handlebar lever
Chokes with handlebar lever
"I'll have a V please, Bob."
-
- Posts: 48
- Joined: 01 Aug 2010 16:28
- Location: Sunshine Coast, Queensland, Australia.
Re: Chokes with handlebar lever
Hi Mark,
Did you sell these chokes? and are you prepared to post them to Australia at my cost?
Cheers
Garry Roberts
Did you sell these chokes? and are you prepared to post them to Australia at my cost?
Cheers
Garry Roberts
Re: Chokes with handlebar lever
I Think you can use them also with a Dellorto 25.
I´m dealing withe the same subject because the normal choke lever bump to the aluminium petro tank taht I´m goin to use. My problem stays the same because the height is the same even using the curved tubes on the carbs.
But trhere is a little diference between the choke pistons, they are longer withr the cable ones as you can see on this picture: ciao norbert
I´m dealing withe the same subject because the normal choke lever bump to the aluminium petro tank taht I´m goin to use. My problem stays the same because the height is the same even using the curved tubes on the carbs.
But trhere is a little diference between the choke pistons, they are longer withr the cable ones as you can see on this picture: ciao norbert
Re: Chokes with handlebar lever
Hi Garry
Sorry for the delayed reply. The chokes have now gone.
Sorry for the delayed reply. The chokes have now gone.
"I'll have a V please, Bob."