3D printed Speedo MPH Bezel

Morini related only please
Post Reply
Jack
Posts: 18
Joined: 05 Feb 2020 15:57
Location: Camberley
Location: Camberley
Contact:

3D printed Speedo MPH Bezel

Post by Jack »

Folks: if anyone is interested my son has just printed me an mph bezel on his 3d printer.
It doesn't look half bad, quite smart.
Unfortunately I cannot upload an image, because my "...board attachment quota...", has been reached, apparently!
However message me and I'll send you a picture of it installed.
The face of my Veglia (Borletti, 220kph) speedo measured 73.21mm across, verniered on the face of the glass, between the case flanges.

If you have a 3d printer I can send you the design, but you will have to put numbers on it, obvious when you see the picture and easy to do. The numbers will need to be 3mm.
If you don't have a 3d printer, and if you ask very nicely the lad may print you one off. He might want a small donation for time and materials.
It is much better than any of the alternatives out there, that I have managed to find, and I have tried a couple.

Please understand there is no guarantee of accuracy, so if you use it and get caught speeding or something, I will accept absolutely no liability!

Anyway, stay well everyone.

Kind Regards
Jack
Post Reply