Kanguro - Front Cylinder Push Rod

Post Reply
jb666
Posts: 182
Joined: 02 Nov 2006 22:20
Location: Ashford, Kent

Kanguro - Front Cylinder Push Rod

Post by jb666 »

The nice shiny bits to resurrect the Kanguro arrived from NLM but they didn't have any front cylinder push rods. Anyone got one available?
User avatar
hombre
Posts: 625
Joined: 09 Apr 2006 16:15
Location: Amsterdam/Alessandria
Contact:

Re: Kanguro - Front Cylinder Push Rod

Post by hombre »

They are probably the same as in all 350's (someone correct me if I'm wrong).
I have one for you...
norbert
Posts: 750
Joined: 15 May 2007 15:15
Location: Lübeck/Germany

Re: Kanguro - Front Cylinder Push Rod

Post by norbert »

They are the same in all 350 motors, with the dirference that in the early motors they were 7mm, later 8 mm turned down to 7 mm at the ends to fit the steel endings. The old ones were 5 gr. lighter 30 in spite of 35 gr. (the main reason to me apears to be the smaller iron part at the upper end)
k-DSCI0183.JPG
k-DSCI0183.JPG (36.99 KiB) Viewed 5651 times
The rear pushrods are about 2 mm longer. The sizes over all front/rear:

500 und 250T: 205/207 (therefore the 250T should be 205)
501: 202/204
350: 182/184

ciao
norbert
User avatar
hombre
Posts: 625
Joined: 09 Apr 2006 16:15
Location: Amsterdam/Alessandria
Contact:

Re: Kanguro - Front Cylinder Push Rod

Post by hombre »

I have these, they vary a bit in lenght :D but should all come from 350-engines

Image
Post Reply