250 2c carb to airbox manifolds

[Parker3865]

Would anyone have the connector pipes and joiner/bush from the carbs to the airbox for the 250 2c v twin. Both sides needed. Part No 30.01.61 x 4 and part No 32.01.48 x 2.
Thanks
Richard Parker

[simonnorthroad]

Ive got one Richard, if you dont find two used. Im in Bath

[Parker3865]

Thanks, I'm in Brentwood,. My daughter at Uni in Bath so I'll let you know if I need it and talk about price than. Many thanks.

[hombre]

Startgomma has those for 125's, don't know if they are the same?

[mbmm350s]

Hello Richard

30.01.61 is same part on Kanguro X, airbox side.
The coupling ring is just a hard plastic stiffener thing - you can 3D print that!
I can measure one for you if needed if no one has them.

The 250 2C uses the two right angle parts coupled together, using the stiffener ring- bingo!

replacement Kanguro part is here:
https://www.startgomma.com/en/manufactu ... ESC&page=3 

Buying 4 is a little bit expensive , so hopefully some kind souls have Kanguro ones.

Mark

[Parker3865]

Thanks for that, very useful information. I'll come back to you about dimensions of the connector if I need to.

[72degrees]

As far as I can see, 30.01.61 is the 90 degree rubber 'elbow' with MM50 moulded in so yes the same as the Camel Start Gomma V619?

For some odd reason I have 3 used ones in the odds and ends box in the shed. There must have been four when I 'broke' the 250 that became the Forgotten Error. No stiffening rings though.

I won't be using them. Postage will be about three quid.
PM me with an offer.

[Parker3865]

Many thanks for all the help. I am sorted now, thanks to the community.