MRC Forum- brought to you by www.morini-riders-club.com

Something deep in my memory remembers a conversation with Alex at NLM (although don't hold me to that) about doing this and him saying that there could be a problem with the flywheel breaking up if you drill the rivets out, i think you need to leave the rivets and sort of cut off the starter drum ro...

I would like to fit a smaller master cylinder to improve my single disc, but does anyone know a suitable smaller modern master cylinder that i could look for on a certain auction site. I'm not bothered about originality so any make would do (though would prefer a italian one, maybe a nice one with r...

I've had a boyer system on my bike for years with no problems (unless you count easy, reliable starting, good low idle speed etc as a problem) i am interested though in the new 300w alternator one of the ignition people are now offering, the only thing i cannot see is as the new flywheel is not posi...

Hi George, thank you very much for those, they are exactly what i needed. Now i just need to find the tools to fit in there

Many thanks, Tony

HI everyone, i wondered if anyone out there could measure the size of a standard 350 tool box (the thing behind the battery, i assume it the tool box!) not sure if they ever changed but my bikes a 1975 (would measure my own but its in Spain at moment, and i'm in the UK). I'm trying to put together a...

Thank you Paul. I think i will starting reporting them and hopefully they will get the message!

Hi everyone again. Sorry but i have now already had two people interested in the 'junk' . So its no longer available. Thanks anyway. Tony

Hi Everyone,I was having a clear out of my garage and came across a motley selection of morini bits that I no longer have any need for. To say that they will need refurbishing is probably a bit of an understatement. But before I take it all to the tip does anyone out there have any need/use for them...

Anybody else sick to death of Brooks Barn flooding ebay with tat no Morini rider would probably want to buy anyway, especially as i'm not sure the disc locks will fit the solid disc on the early ones! Or am i just get grumpy??

Hi Derek,

PM sent,

Regards, Tony

Hi everyone i've been having a clearout and have a large collection of old ATG's to get rid of (about 100 or so from about 94-04). If anyone wants them they can have them FOC but would need collecting from Northampton as too heavy/costly to post.

Cheers, Tony

Hi, sorry to ask what is possibly a obvious question, but is there any difference between to two types shown? Which ones are best? the roller type or ball?

Thanks, Tony

Hi there, sadly you have to take the whole clutch and also the side casing off to access them (and all other bits and pieces removing the casing involves) not a two minute job but not too bad. Do you have a parts book? if so the washers are on Table No. 1 item 29 (Part no. 21.01.53). You'll notice y...

Hi, not sure if this may help, but many years ago i rebuilt my 350 and suffered the same problem, a small oil leak that appeared to be coming from where the crankcases join just behind the rear cylinder. I took the barrels off and tried new gaskets, no better, then gaskets and goo but still the leak...

Hi all, not sure if this has been asked before but can anyone recommend a supplier of throttle cables that are actually the right length for my 1975 sport? The ones i have on at the moment do not allow me to have a locking nut on the carb/cable adjuster because they are too short and therefore my ca...