MRC Forum- brought to you by www.morini-riders-club.com Member: g7AW3f

Not sure where to put this, so here it is. I have been using the following to help me with a few Morini matters. Apologies if they are well known
Many useful resorces:-
https://hofmann-andi.de/MoriniWebsite/Willkommen.html
I have been making use of the CAD data with my 3D printer.

The local Dutch resources still seem to be down, in the meantime:-
http://hogervorst.tech/moto_morini_club_nederland/
In Dutch so use your browser to translate. I have been renewing my knowledge of the stator and ignition system to solve my 250s current problem. See the post in the Weevees section.

Again, apologies if the is the wrong section and also if they are well known.

Hi Richard

I'm just about ready to launch the new website, so I'll add this to the links.

The Dutch site went down at the same time as the forum when the bots took over a couple of months back. I got this one back online and I'll be updating the software once the new site is up an running. Once all that's done, I'll have a look at bringing the Dutch site back to life. I found the ignition section really useful, so I haven't forgotten about it, just a matter of priorities!

I think we all apreciate the hard work that goes on in the background, many thanks.

BarryCambs wrote: ↑12 Dec 2025 20:18 Hi Richard

I'm just about ready to launch the new website, so I'll add this to the links.

The Dutch site went down at the same time as the forum when the bots took over a couple of months back. I got this one back online and I'll be updating the software once the new site is up an running. Once all that's done, I'll have a look at bringing the Dutch site back to life. I found the ignition section really useful, so I haven't forgotten about it, just a matter of priorities!

Your hard work is much appreciated.