Page 1 of 1
Ignition switch
Posted: 04 Jun 2021 13:39
by Hugo
Whilst changing the binnacle on the 250c I managed to detach the wires from the ignition switch, it's a 6 pole switch but 4 wires,brown, blue, green and red which is still attached to terminal 6, can someone guide me please
Re: Ignition switch
Posted: 07 Jun 2021 13:10
by mbmm350s
Hello,
Hugo
The original 2C switch only had four terminals, so most likely its a replacement. If its a CEV its likely from a later kanguro or Camel which share the same binnacle or a similar one with extra idiot lights. It could also be a generic switch from a moped e.g. a Honda PX50 /melody
You will need to remove the switch and check the internal connections in each switch position, using a meter.
What you need to provide is:
OFF - key removable green wire connects to blue wire, red wire NOT connected to brown wire
ON - Key not removable green wire disconnected from blue wire, red wire connected to brown wire
On an adapted 6 pole
Normally 1 and 2 are green/blue (you can swap 1 and 2)
5 and 6 are red/brown (you can swap 5 and 6)
On a standard wired 250 2C no other connections are made or needed (no park light position)
You may find the switch has three positions.
This can also be adapted to work.
Mark