Inlet rubber "Ring" 32.01.32
Posted: 28 Oct 2024 12:13
I notice in the parts book there is a plastic ring that fits at the engine end of the inlet rubber, No 26:
0
I haven't been using them, so got a pair from Mdina:
My 2 questions are
1) Are they needed?
2) The pair I have bought seem a little longer than where they fit, is this correct, or does their length need shortening a bit?
- Screenshot_20241028-121026_1.png (349.81 KiB) Viewed 448 times
I haven't been using them, so got a pair from Mdina:
- IMG_20241028_110443.jpg (486.05 KiB) Viewed 448 times
1) Are they needed?
2) The pair I have bought seem a little longer than where they fit, is this correct, or does their length need shortening a bit?