Wiring help - NLM Transducer kit with coils

[AK99]

Gentlemen / ladies,

Apologies for the ongoing chain of queries in the Strada recommissioning challenge. I had the bike together and running weekend before last, and took it for a shakedown spin round the local area. Got a little bit overconfident and went further than I should until (probably not entirely unforeseeable since it was the first proper shake-down run). To cut a long story short - zero spark.

After a couple of false starts, I believe I've narrowed the problem down to a fault on the feed to the coils. The bike has been fitted with the NLM transducer, and a set of two coils which don't seem to have any identifying marks on them.

The wiring connection to the coils and between the coils and transducers seems to tie up perfectly with the tech info about the kit in the members tech area on here. The problem I have is that the circuitry before that doesn't tie up with any of there wiring diagrams I've been able to find so far.

The +ve feed to the coil is a black wire for example, which disappears back into a larger bundle that heads back towards the fuesebox, but I'm struggling to figure out how the rest of the loom prior to that is supposed to look.

The bike was originally an Italian market 1978 model Strada with electric start. The only 350 electric start wiring diagram I have been able to find so far is the one in the technical area here - but I can't tie what's on the bike to it especially around the inputs to the coil-transducer components.

Would anybody be able to point me to any other wiring diagrams which might be closer to what's on the bike ?

[JonD]

I have sent you a Private Message about the wiring diagram and NLM transducers.

[AK99]

I got that Jon - and replied to you.

Many thanks, appreciated.

Alan