MRC Forum- brought to you by www.morini-riders-club.com

Taken from the PHBH 28s on my 501 motor, but the dimensions appear identical to the 350 chokes. Handlebar lever and back-plate included; you'll just need a bracket. This pivoted on the clutch lever pivot bolt. £20 including p&p in the UK. PM me with any questions. Thanks, Mark.

Hi Mark,
Did you sell these chokes? and are you prepared to post them to Australia at my cost?
Cheers
Garry Roberts

I Think you can use them also with a Dellorto 25.

I´m dealing withe the same subject because the normal choke lever bump to the aluminium petro tank taht I´m goin to use. My problem stays the same because the height is the same even using the curved tubes on the carbs.

But trhere is a little diference between the choke pistons, they are longer withr the cable ones as you can see on this picture: ciao norbert

Hi Garry

Sorry for the delayed reply. The chokes have now gone.