Kanguro X2 / X3 Leovinci silencers
Posted: 21 Aug 2025 16:42
These silencers came attached to a Kanguro X1 project bike I've been working on for a while. They did look very nice on the bike. However, the exhaust pipework connecting into them had been cut, re-routed, re-welded etc. in a bad way, to the point where I've replaced it all with the standard X1 2-into-1 complete system.
Consequently, these silencers are now surplus to requirement. The condition looks to be OK. As can be seen from the photos specs of rust are present through the black coating but otherwise structurally sound.
NOTE THAT THE HEAT SHEILD PILLARS HAVE BEEN CUT OFF. Sorry, not not my doing. I think it may have been an attempt by a previous owner to accommodate the silencers body underneath the X1 side panels.
Not shown, but I'll include a couple of clamps, (rusty but still functional).
£100 o.n.o. plus £10 post and packaging
Chris I.
North Yorkshire.
Consequently, these silencers are now surplus to requirement. The condition looks to be OK. As can be seen from the photos specs of rust are present through the black coating but otherwise structurally sound.
NOTE THAT THE HEAT SHEILD PILLARS HAVE BEEN CUT OFF. Sorry, not not my doing. I think it may have been an attempt by a previous owner to accommodate the silencers body underneath the X1 side panels.
Not shown, but I'll include a couple of clamps, (rusty but still functional).
£100 o.n.o. plus £10 post and packaging
Chris I.
North Yorkshire.