Inlet rubber "Ring" 32.01.32

250 2c- the Wee-WeeVees
Post Reply
User avatar
Parker3865
Posts: 130
Joined: 13 Sep 2022 18:16
Location: Brentwood
Contact:

Inlet rubber "Ring" 32.01.32

Post by Parker3865 »

I notice in the parts book there is a plastic ring that fits at the engine end of the inlet rubber, No 26:
Screenshot_20241028-121026_1.png
Screenshot_20241028-121026_1.png (349.81 KiB) Viewed 444 times
0
I haven't been using them, so got a pair from Mdina:
IMG_20241028_110443.jpg
IMG_20241028_110443.jpg (486.05 KiB) Viewed 444 times
My 2 questions are
1) Are they needed?
2) The pair I have bought seem a little longer than where they fit, is this correct, or does their length need shortening a bit?
Morini 250 2c rebuilt from a box of bits.
norbert
Posts: 825
Joined: 15 May 2007 15:15
Location: Lübeck/Germany

Re: Inlet rubber "Ring" 32.01.32

Post by norbert »

They are just to proyecto the rubbers because the clamps may hurt them. I use them on both ends of te inlet rubbers
Post Reply